川消濕式報警閥慢報警問題的探討
來源：http://m.xintli.net/ 日期：2022-08-31
在濕式自動噴水滅火系統的消防工程中，有時會遇到濕式報警閥動作不及時、報警時間慢的現象。下面就來講講
川消濕式報警閥慢報警問題內容。
In the fire protection engineering of the wet automatic sprinkler system, sometimes the wet alarm valve does not act in time and the alarm time is slow. The following is about the slow alarm of the wet alarm valve of Chuanxiao.
同廠家制造同型號規格的多臺報警閥組安裝在同一消防工程中（而控制區域不同時），當進行放水試驗時，有的報警時間快，幾分鐘警鈴就響了，個別的報警時間長達十幾分鐘，甚幾十分鐘才能報警。當發生這種情況時，許多使用單位就認為產品質量不好，甚連消防檢測或驗收人員都可能認為產品有問題。
Several alarm valve groups of the same model and specification manufactured by the same manufacturer are installed in the same fire protection project (while the control area is different). When the water discharge test is carried out, some alarm time is fast, and the alarm bell rings in a few minutes, and some alarm time is as long as ten minutes, or even tens of minutes. When this happens, many users think that the product quality is not good, and even the fire detection or acceptance personnel may think that the product is defective.
濕式報警閥調試時，在試水裝置處放水，當濕式報警閥進口水壓大于0.14MPa、放水流量大于1L/s時，報警閥應及時啟動；帶延遲器的水力警鈴應在15—90s內發出報警鈴聲，不帶延遲器的水力警鈴應在15s內發出報警鈴聲；壓力開關應及時動作，并反饋信號。
During commissioning of the wet alarm valve, water shall be discharged from the water testing device. When the inlet water pressure of the wet alarm valve is greater than 0.14MPa and the discharge flow is greater than 1L / s, the alarm valve shall be started in time; The hydraulic alarm bell with delay shall send out the alarm bell within 15-90s, and the hydraulic alarm bell without delay shall send out the alarm bell within 15s; The pressure switch shall act in time and feedback the signal.
噴頭或試水裝置放水時，報警閥應及時動作。如果根據上述三個規范（規程）的內容進行驗收，這種動作不及時、報警時間慢一些的報警閥組很有可能被用戶或消防權威機構判定為不合格產品。那么在工程應用中出現報警閥這種慢報警的現象到底是產品技術有問題呢？還是由于其它原因造成的呢？這就需要從濕式報警閥的工作原理談起。
When the sprinkler or water testing device discharges water, the alarm valve shall act in time. If the acceptance is conducted according to the contents of the above three specifications (procedures), the alarm valve group with delayed action and slower alarm time is likely to be judged as unqualified by the user or the fire authority. So what is the problem with the product technology that causes the slow alarm of the alarm valve in the engineering application? Or is it caused by other reasons? This needs to start with the working principle of the wet alarm valve.
其實濕式報警閥就是一個增加了在閥瓣開啟狀態下有能夠進行自動報警功能的單向止回閥，只允許水流從供水側流向管網側。自動噴水滅火系統伺應狀態時，整個管網充滿設計要求的壓力水，濕式報警閥閥瓣由自重而關閉。
In fact, the wet alarm valve is a one-way check valve with automatic alarm function when the valve flap is opened, which only allows water flow from the water supply side to the pipe network side. When the automatic sprinkler system is in the standby state, the entire pipe network is filled with the pressure water required by the design, and the valve disc of the wet alarm valve is closed by its own weight.
在濕式系統保護區內，一旦發生火災，在火災溫度的作用下，使閉式噴頭感溫啟動，噴水滅火。這時濕式報警閥管網一側水壓下降，閥瓣上、下腔形成壓差，在水流作用下，閥瓣開啟并供水滅火。同時一部分水流入報警管道，使水力警鈴發出響聲報警，并使壓力開關動作將電信號傳報警控制中心，發出聲光報警。
In the wet system protection area, once a fire occurs, the closed sprinkler will be started by temperature sensing under the effect of fire temperature, and the sprinkler will extinguish the fire. At this time, the water pressure at one side of the wet alarm valve pipe network drops, and the pressure difference between the upper and lower chambers of the valve flap forms. Under the action of water flow, the valve flap opens and supplies water for fire extinguishing. At the same time, a part of the water flows into the alarm pipeline, causing the hydraulic alarm bell to give a sound alarm, and causing the pressure switch to act to transmit the electric signal to the alarm control center to give an audible and visual alarm.
川消濕式報警閥慢報警問題的探討就到這里了吧，您對此有什么不了解的問題就來我們網站
http://m.xintli.net咨詢了解吧！
This is the end of the discussion on the slow alarm problem of Chuanxiao wet alarm valve. If you have any questions about this, please come to our website http://m.xintli.net Consult and understand!
