消防信號閘閥的保管、保養、安裝和使用！
來源：http://m.xintli.net/ 日期：2023-02-04
消防信號閘閥除具有彈性座封閘閥的優點之外，并可以較直觀顯示閥門開啟程度，以便能在較遠處判別閥門的開度，及時采取相應措施。下面
川消廠家來為您講講：消防信號閘閥的保管、保養、安裝和使用！
In addition to the advantages of the resilient seat gate valve, the fire signal gate valve can also visually display the opening degree of the valve, so that the opening degree of the valve can be judged at a distance and corresponding measures can be taken in time. Next, the manufacturer of Chuanxiao will tell you about the storage, maintenance, installation and use of fire signal gate valve!
消防信號閘閥應存放在干燥，通風的室內，消防信號閘閥通道兩端應堵塞。
The fire signal gate valve shall be stored in a dry and ventilated room, and both ends of the fire signal gate valve channel shall be blocked.
長期存放的消防信號閘閥應定期檢查，污物。應特別注意密封面的清潔，防密封面的損壞。
The fire signal gate valve stored for a long time shall be inspected regularly to remove dirt. Pay special attention to the cleanness of the sealing surface to prevent the damage of the sealing surface.
安裝前應仔細核對消防信號閘閥標志是否與使用要求相符。
Before installation, carefully check whether the sign of fire signal gate valve conforms to the use requirements.
安裝前應檢查消防信號閘閥內腔和密封面，如有污垢，應使用清潔布擦拭干凈。
Before installation, check the inner cavity and sealing surface of the fire signal gate valve. If there is dirt, clean it with a clean cloth.
安裝前檢查填料是否壓緊，應確保填料的密封性，同時不應妨礙閥桿的轉動。
Before installation, check whether the packing is tight, ensure the sealing of the packing, and do not hinder the rotation of the valve rod.
安裝后系統或管路試壓時，消防信號閘閥應處于全開位置。
During the pressure test of the system or pipeline after installation, the fire signal gate valve shall be in the fully open position.
使用中，應將閘板全開或關閉，不應將閘板部分開啟做調節流量用。
In use, the ram shall be fully opened or closed, and the ram shall not be partially opened for flow regulation.
使用時，應經常給閥桿梯形螺紋注入潤滑劑。
When using, lubricant should be injected into the trapezoidal thread of the valve rod frequently.
手動消防信號閘閥，在開啟或關閉操作時，應使用手輪開、關，不得借助輔助杠桿或其它工具。
When opening or closing the manual fire signal gate valve, the hand wheel shall be used to open and close it, and the auxiliary lever or other tools shall not be used.
The fire signal gate valve shall be inspected regularly after use to check whether the sealing surface, valve rod, etc. are worn and whether the gasket and packing are available. In case of damage or failure, repair or replace it in time. Come to our website for more relevant content http://m.xintli.net Consult!
