聯系我們
來源：http://m.xintli.net/ 日期：2023-12-25
消防水帶是用來運送高壓水或泡沫等阻燃液體的軟管。傳統的消防水帶以橡膠為內襯，外表面包裹看亞麻編織物。的消防水帶則用聚氨酯等聚合材料制成。消防水帶的兩頭都有金屬接頭，可以接上另一根水帶以延長距離或是接上噴嘴以增大液體噴壓力。
Fire hose is used to transport high-pressure water or foam and other flame retardant liquids. Traditional fire hoses are lined with rubber and wrapped in linen woven fabric on the outside. Advanced fire hoses are made of polymer materials such as polyurethane. Both ends of the fire hose have metal joints, which can be connected to another hose to extend the distance or to a nozzle to increase the liquid spray pressure.
型65-25米 消防水帶
Type 65-25 meter fire hose
消防水帶正確的使用方法
Correct usage of fire hoses
打開防火栓門，取出水龍帶水槍。
Open the fire hydrant door and remove the hose and water gun.
檢查水帶及接頭是否良好，如有破損嚴禁使用。
Check if the water hose and joints are in good condition. If there is any damage, it is strictly prohibited to use.
向火場方向鋪設水帶，避免扭折。
Lay water hoses in the direction of the fire to avoid twisting and folding.
將水帶靠近消火栓端與消火栓連接，連接時將連接扣準確插入滑槽，按順時針方向擰緊。
Connect the water hose close to the end of the fire hydrant and connect it to the fire hydrant. When connecting, insert the connecting buckle accurately into the sliding groove and tighten it clockwise.
將水帶另一端與水槍連接(連接程序與消火栓連接相同)。
Connect the other end of the hose to the water gun (the connection procedure is the same as that of the fire hydrant).
連接完畢后，少有2人握緊水槍，對準火場(勿對人，防止高壓水傷人)。
After the connection is completed, at least 2 people should hold the water gun tightly and aim it at the fire scene (do not face people to prevent high-pressure water from injuring people).
緩慢打開消火栓閥門，對準火場根部進行滅火。
Slowly open the fire hydrant valve to the maximum and aim at the root of the fire to extinguish the fire.
消防水帶連接，消防消防水帶在套上消防水帶接口時，須墊上一層柔軟的保護物，然后用鍍鋅鐵絲或喉箍扎緊。
Fire hose connection: When the fire hose is connected to the fire hose interface, a layer of soft protective material must be placed on it, and then it should be tied tightly with galvanized iron wire or hose clamps.
消防水帶的使用。使用消防消防水帶時，應將耐高壓的消防水帶接在離水泵較近的地方，充水后的消防水帶應防止扭轉或驟然折彎，同時應防止消防水帶接口碰撞損壞。
The use of fire hoses. When using fire hoses, high-pressure resistant fire hoses should be connected closer to the water pump. The filled fire hose should be prevented from twisting or suddenly bending, and the fire hose interface should be prevented from collision and damage.
消防水帶鋪設。鋪設消防水帶時，要避開夾銳物體和各種油類，向高處垂直鋪設消防水帶時，要利用消防水帶掛鉤，通過交通要道鋪設消防水帶時，應墊上消防水帶護橋，通過鐵路時，消防水帶應從軌道下面通過，避免消防水帶被車輪碾壞而間斷供水。
Fire hose laying. When laying fire hoses, avoid sharp objects and various oils. When laying fire hoses vertically upwards, use fire hose hooks. When laying fire hoses through traffic arteries, a fire hose protection bridge should be placed. When passing through railways, fire hoses should pass under the track to avoid being crushed by wheels and interrupting water supply.
防止結冰。嚴冬季節，在火場上需暫停供水時，為防止消防水帶結冰，水泵需慢速運轉， 保持較小的出水量。
Prevent icing. In the harsh winter season, when water supply needs to be suspended on a fire site, in order to prevent the fire hose from freezing, the water pump needs to run slowly to maintain a small water output.
消防水帶清洗，消防水帶使用后，要清洗干凈，對輸送泡沫的消防水帶，必須細致的洗刷，保護膠層。為了消防水帶上的油脂，可用溫水或肥皂洗刷，對凍結的消防水帶，要使用之融化，然后清洗晾干沒有晾干的消防水帶不應收卷存放。
The fire hose shall be cleaned after use. The fire hose conveying foam must be carefully washed to protect the adhesive layer. To remove grease from fire hoses, warm water or soap can be used to wash them. For frozen fire hoses, they should be melted first, and then cleaned and dried. Fire hoses that have not been dried should not be stored in rolls.
感謝您的閱讀，此文的文章來源：川消更多的內容和問題請點擊：http://m.xintli.net我們會繼續努力的為您提供服務，感謝您的支持！
Thank you for reading. The source of this article is Sichuan Consumers. For more information and questions, please click: http://m.xintli.net We will continue to work hard to provide you with services. Thank you for your support!
